Monitors vanish from system with 1703 update

Post Reply
gareth
Posts: 9
Joined: Wed Oct 28, 2015 8:03 am

Monitors vanish from system with 1703 update

Post by gareth » Mon Aug 21, 2017 7:52 am

I had Aster 2.18 running, then the 1703 update installed.
Then when Terminal1 was idle, the monitor shut off. Nothing I did would revive it so I restarted the computer from Terminal2.
On reboot, the Windows Control Panel no longer shows any monitors on my system other than the Terminal 2 monitor, which is not even the monitor that the Bios uses when booting up the computer.
So now I can no longer even try to use these monitors, with or without Aster activated. I disabled/rebooted aster, re-enabled, disabled&rebooted then uninstalled. And still those monitors no longer show up in my device manager.
I have uninstalled the video card driver, and reinstalled. Uninstalled the monitor driver that IS working and reinstalled, still the other monitor does not show up. Normally Aster shows 4 monitor devices because that is what my video card has ports for, but I only have 2 monitors actually plugged in to the computer.
This is the second time this problem has happened with this 1703 update. The first time which was a few days ago, I formatted my computer and reinstalled everything in order to be working again. Then the update happened again and now I am back to broken.
I also tried "rolling back to the previous version of windows" like they have built in to windows 10, but it did not work.

please help! I don't know what it is Aster changes to the system to make it do what it does, but whatever it is, does not go away when the software uninstalls

d-dsn
Posts: 2
Joined: Fri Jan 02, 2015 3:18 pm

Re: Monitors vanish from system with 1703 update

Post by d-dsn » Thu Sep 07, 2017 4:27 pm

I'm having the same problem and so far the solution is to postpone windows update again and again.
I would not like to do this forever, so I hopefully there is a solution!

Everytime there's a new Windows 10 build, Aster just breaks after update

kurasov1965M
Posts: 8
Joined: Wed Sep 20, 2017 11:58 am

4 Monitors vanish from system with 1703 update

Post by kurasov1965M » Fri Sep 22, 2017 12:08 am

I have installed ROSAs offical WINE for 64 bit systems, but it doesnt seem to be working. I tried using the configure wine program would not run at all and tried to install a Windows program that I used with Wine successfully on another linux system, but the setup.exe wont start. Anyone know why? Thanks, ROSA is beautiful polished user interface- my new favorite linux.

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests